What have you done for your Z today?
#1962
New Member
iTrader: (1)
Join Date: May 2012
Location: Savannah, GA
Posts: 83
Likes: 0
Received 0 Likes
on
0 Posts
Finally got the RJM bracket installed, but haven't adjusted it yet, so its all wonky .
The slider at 3/4 is too soft and the clutch rod is thread too far in so engagement is off
Unfortunately had to drop the Z off for recall repair (fuel filler hose) today, so guess I'll fix it tomorrow afternoon.
The slider at 3/4 is too soft and the clutch rod is thread too far in so engagement is off
Unfortunately had to drop the Z off for recall repair (fuel filler hose) today, so guess I'll fix it tomorrow afternoon.
#1964
Registered User
iTrader: (2)
Join Date: Aug 2011
Location: Biloxi, MS
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
Key!s Racing Steering added about a month ago. Best wheel ever. Hands down.
Threw on the cooling panel I got from Bmurray350z today.
Annnd...that's heat tape around the intake filter for the ones that want to know. :/
Threw on the cooling panel I got from Bmurray350z today.
Annnd...that's heat tape around the intake filter for the ones that want to know. :/
#1980
Registered User
iTrader: (14)
Not all done today but this week
I noticed the bolts on the strut bar were stripped and bent, so I cut them off
Replaced with these...not sure how I feel about it, but I wanted something different. I don't think its really even noticeable.
Then I removed all the stuff to wash the engine bay. Ill be putting it back together tomorrow
I noticed the bolts on the strut bar were stripped and bent, so I cut them off
Replaced with these...not sure how I feel about it, but I wanted something different. I don't think its really even noticeable.
Then I removed all the stuff to wash the engine bay. Ill be putting it back together tomorrow
Last edited by BEBO'S ZEE; 07-14-2012 at 12:32 AM.