Drift setup
09-01-2015, 10:58 PM
#2
Registered User
Join Date: Mar 2014
Location: DXB-UAE
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
I had the PBM angle kit which was running fine, KTS coilovers and full rear adjustable arms from eBay, setup was good to start with.
Now will be getting wisfab front and rear, feel suspinsion, solid bushings for the diff and subframe.
Now will be getting wisfab front and rear, feel suspinsion, solid bushings for the diff and subframe.
09-01-2015, 11:22 PM
#3
Registered User
Thread Starter
Join Date: May 2015
Location: United States
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
No sway bars? And how much do you think that setup ran you?
09-02-2015, 08:05 AM
#4
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
I wonder if anyone in this section of the forum has set up a car for drift https://my350z.com/forum/drift-308/
09-02-2015, 08:40 AM
#5
Super Moderator
MY350Z.COM
MY350Z.COM
I wonder if anyone in this section of the forum has set up a car for drift https://my350z.com/forum/drift-308/
Thread moved...
09-03-2015, 06:59 AM
#7
Registered User
Well, for my initial drift setup, it differed quite a bit from my street setup. I would put my right foot on the gas and the left foot on the clutch, but I depressed it a LOT more than when I was cruising on the street.
Then, I upgraded to using more power over. It's not a PBM angle kit, but it gets the job done. Basically, drive. The Z's drift stock.
Then, I upgraded to using more power over. It's not a PBM angle kit, but it gets the job done. Basically, drive. The Z's drift stock.
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM
350Z_Al
Exterior & Interior
133
10-29-2020 07:44 PM
350Z Project X
Suspension
9
10-10-2015 09:23 AM
