Back glass on 06 350Z
#1
Registered User
Thread Starter
Join Date: May 2016
Location: South Carolina
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Back glass on 06 350Z
I have a 2006 350Z convertible top works great only thing is when after putting the top down a few times the seal around the back glass that seals the top to the rear glass wants to come loose,,,still sealed to inner seal no leaks,,,whats the best way to reseal the seal where the top meets the glass,, like a little flap that comes loose just in certain areas,,,is there a sealant best for this or should I just call a glass co about resealing it,,,Thanks,,,new to site so any help would be greatful...
#3
Registered User
Thread Starter
Join Date: May 2016
Location: South Carolina
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
the dealer I bought it from will fix it under the extended warrenty I bought,,,local glass guy gave me some window resealant to try it myself,,, just haven't tried it yet,,,hate screwing with dealers but might have to,,;
#6
Registered User
Thread Starter
Join Date: May 2016
Location: South Carolina
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
finally got my glass to reseal,,, was recommended 3M 08609 called wind-weld,,,,cleaned surface around glass seal and where top meet with,,,i used brake clean and a rag got all dirt and old sealant off,,,goes on with a caulk gun ,,, pull flap back caulk it where glass meets top push down to seal,,, starts to get tacky after a few minutes,,,i let mine set up over night,,,that was a few weeks ago,,,used top a lot since and glass still sealed to top,,, so far so good ,, the 3M is used to seal windshields that have no molding,,
Last edited by Jimmys 350Z; 10-19-2016 at 04:51 PM. Reason: add to
Thread
Thread Starter
Forum
Replies
Last Post