[JasonZ-YA]

Okay,

I started off by driving out to the local hardware store. I picked up an 3/4 inch aluminum square tubing. 4 ft was the smallest they had. so for about 6 bucks in aluminum you can make two of these camera mounts since you only need about 22 inches total length to make one.

I then measured out the head rest mount locations and drilled two 9/16 holes.

Then i drilled out the camera mount hole.
after reading the entire DIY you will see which camera mount design you may want, and decide what size hole to drill. either a small hole for the M4 bolt or 1/4 hole for 1/4 wing screw.

DFW:
If your local to DFW and wanna make one, come over and bring some pizza and a six pack and well knock it out one day!

If not local, pm me and we can work something out. I have already made two and shipped them for members.
-J