JonsilvZ

I just got this Bell g-tech. I did a good run and here are the results:

60ft-2.0
330ft-5.8
0-60-5.2
0-100-13.4
1/4-13.8@100.6

This was in manual mode. Full auto was 14.3@97 The shifts seem slower in full auto. All done on the same road.

soupnazi1

Very impressive!

lemonjihwan

iTrader: (5)

Are you sure?
then what can you get with 6spd Touring Z, if you are decent driver?

Street Visionz, Inc.

iTrader: (68)

whats your launch technique?

dchengmd

Wow, that is the fastest 1/4 I've seen from a stock 5AT. Congrats.

Hupperware

BS... try the track, post the paper slip... starting from a roll doesn't count.

FLY BY Z

GTech<Actual Track

look, it took you .4 seconds to go from 100 to 100.6 MPH. That thing is OFF.

myinfinitig20

look at motortrend times for the z in the latest mag....same problems when you look at the mph in the 1/4 and the 0-100 times

JonsilvZ

My actual time at the drag strip was 14.0 so I'm not too far off from 13.8 I took off from idle and hooked up better then the 14.0 at the strip.

JonsilvZ

Here is the latest test from Motor Trend:

0-100-13.0
1/4-13.77@100.94

.7 sec???

jackie chan

iTrader: (1)

a gtech is not a proper timing device. i hope you dont tell people your car runs those times now. 14.0 is pretty good though, it will go 13's on a real track you just need to make a few more passes

JamRWS6

it took you .4 seconds to add .6 mph.....i hope that thing is off! lol

i don't know about that thing but i know that the mph on the gtech pro is ridiculously off....it read 114 in the 1/4 when i did mine

zerobanger

N74DV

it's possible.

my Auto does a 0-60 between 4.9 and 5.2 with a fastest 1/4 mile of 13.8

My measurements were taken with the AutoEnginuity OBDII software running SpeedTracer.

My only significant mod is the Borla.

of course his erroneous time reading between 100-100.6 is a little wierd.

BRONXWARRIOR

ill have to race you now jonsilvz


AUTOS ROCK



HAHA SICK

JonsilvZ

I tell people that my real track time is 14.0 and my Bell gtimer is 13.8 When I raced a mod wrx(turbo boost,intake,exhaust) from a 10mph roll we were even to 120 then i started to pull on him. After the race he tells me to pop the hood. Another race with a 350Z 6sp(CAI) he had the first jump(half car) was staying there 100+. He also tells me to pop the hood. They dont believe that my Z is bone stock AUTO. Well I have A/S tires.

Street Visionz, Inc.

iTrader: (68)

Actually Jons the reason why you see in motor trend the 0-100 being 13 seconds and the 1/4 at 100.94 being 13.77 seconds is because trap speeds are calculated way differently at the track. I remember reading something saying its not the actual speed you pass the 1/4 mile at, but an average of a couple of speeds. Dunno I need to find that article again.

Street Visionz, Inc.

iTrader: (68)

btw I think autos can hit 13s stock...I hit 14.1 elevation corrected with a crappy 2.2 60 ft time. That's without lowering tire pressure or taking out the spare or anything. If I can nail a 2.0 next time around I think 13.9s won't be that hard.

JamRWS6

I've really DRUUUUG some people before and never have they asked to see under the hood Is this commonplace in your area?

Daytona Blue Z in Bo

Last time I went to the track I tested my G-Timer 2 vs My time slip.

It went something like this..

Time slip:
14.11@100.56

G-Timer 2:
14.08@99.88

And the 60 foot times were nearly identical around 2.25 or so.

I also managed a 13.82@102.xx with a 2.08 60 on it. If it's calabrated correctly and your on a flat road it can be very close. But I still would not take credit for a run unless it was in the form of a timeslip from the track.

The performance devices are more of a guide to compare runs or mods, they are very accurate in this regard.