How can I tell if my OEM dual mass flywheel is bad?
#1
Registered User
Thread Starter
Join Date: Jul 2012
Location: Atlanta, GA
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
How can I tell if my OEM dual mass flywheel is bad?
What generally happens when these go bad? I have the flywheel out of the car and it seems to have some play in it- is that normal?
Thanks for helping the noob!
Thanks for helping the noob!
Last edited by hunterg; 08-13-2012 at 04:29 PM.
#2
Registered User
Thread Starter
Join Date: Jul 2012
Location: Atlanta, GA
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
I believe I've found the answer
From service manual...
The "movement amount of radial direction" was what I was referring to in the original post. Basically there should be a specified amount of radial play when a specified amount of force is applied.
The "movement amount of radial direction" was what I was referring to in the original post. Basically there should be a specified amount of radial play when a specified amount of force is applied.
#4
Registered User
Thread Starter
Join Date: Jul 2012
Location: Atlanta, GA
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
I have not driven the car with this flywheel. Previous owner installed a lightweight flywheel and 6 puck clutch combo, which is not very drivable for my sister. Reinstalling stock components- original clutch and flywheel have about 25k miles on them
#5
Registered User
iTrader: (1)
If it makes a ton of noise engaged at low RPM's then it's probably no good, but it's not going to change the drivability. I've never seen them 'go bad' though... since they are typically not able to be resurfaced your not going to be on the same flywheel long enough for it to 'go bad'.
Trending Topics
#9
New Member
iTrader: (1)
I just had my flywheel replaced with another OEM DM flywheel. Nissan was trying to address a bouncing tachometer and thought maybe it had something to do with it. The answer was yes and no. While my tach doesn't bounce as much, it still bounces. But it still contributed to added movement in my tach and I could audibly hear the engine oscillating prior to the replacement. My clutch wasn't slipping and Nissan confirmed that. I think the flywheel was just beyond the standard radial movement. Otherwise the car drove fine.
Thread
Thread Starter
Forum
Replies
Last Post