help on sub wiring

[bbak11010]

hey all, just a quick question for wiring the subs.
I have two 10" Image Dynamics ID10V3D4 trying to connect to
Image dynamics Q600.1 mono amplifier.
I purchased these from Woofersetc and the guy told me to wire it this way.
I just want to check if this is a right way to wire them.
Any help is appreciated, and sorry for the crappy drawing.

[Z1NONLY]

^^^No.

Your pic would only make one coil on one sub operate.

I just googled your amp and found this....

http://www.imagedynamicsusa.com/pdf/...al%20Q-amp.pdf

It says your amp is stable into 1 ohm. I had less luck googling your subs but the part number seems to indicate dual 4 ohm voice coils on each.

If this is correct, all you need to do is connect each + terminal on ech voice coil to the + speaker output on your amp. Then connect each - terminal on each voice coil to the - speker terminal on your amp.

If your subs have dual 4 ohm coils, this will create a 1 ohm load.

I am on my way out the door, or I would draw a pic for you, but for now that's the best I can do.

If any of my assumptions for your equipment are incorrect, disregard my post. For instance, if your subs have dual 2 ohm coils, this could fry your amp.

Hope this helps.

[KPierson]

If they are single coil subs then the picture will work.
If they are dual coil subs the picture will not work.

I did a quick search for the model number but didn't see any relevent specs. Can you provide more information as to the impedence or number of coils per sub?