DIY License Plate Light Change
#41
Registered User
#43
New Member
iTrader: (1)
Thanks for a good post-only problem I'm having is that the bulb housing may have warped over time-I got an '04-might be able to extend the little tab that sticks out(the little tab that's on the opposite side of the v-shaped clip on the housing-I might get a little piece of hard plastic+crazy glue it on the bottom of the little tab to make it work-it's just not secure as it was before-
#46
New Member
I swapped out my entire light housings for pre-builds with 16 white led's in each. Lights up the entire back of the car now. Only got pulled over once. Cop said I was illuminating my license TOO well. I never removed the bulbs, just went by to get the fix-it ticket cleared in broad daylight and they cleared it.
#47
Registered User
iTrader: (15)
I've had LEDs in mine for several years, but went with the dimmest white ones I could find. Similar to original bulbs, but whiter. No point in attracting attention or making the rear plate too easy to see, As an aside, I would never be stupid enough to tint heads, tails, signals, reverse lights, etc.
Thread
Thread Starter
Forum
Replies
Last Post