HOW2: Remote Key Fob Programming
#44
Registered User
Thanks for this clear explanation. Worked great on a $6 fob from Amazon! One thing to note, car locks itself after a minute or so if you've been using the fob to lock/unlock it.
#46
Registered User
Bumping an old thread, but I just bought a ZR that only came with 1 key and fob. Going to order a new fob so if I were to somehow loose my key or lock myself out, I can get inside. Then get a new/second key cut, and rip them apart to build a switchblade key .
#48
Registered User
Me too
Tried this in my Z350 2003 Track but it did not work - instead of the lights flashing - the doors would unlock and will not enter the programing mode. Any ideas? how i can make it work. I have seen other peole in the net having the same issue but no solution was suggested.
#49
New Member
#50
Registered User
Join Date: Mar 2022
Location: Washington dc
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Key fob programming messed up my working fob
1. Close and lock all doors with the driver’s side power lock/unlock switch.
2. Insert key in ignition and remove it from the ignition key cylinder a minimum of six times within 10 seconds. Your hazard lamps will flash if you have performed this step successfully. (Withdraw key completely from ignition cylinder each time). If this procedure is performed too fast, system will not enter programming mode.
3. Insert key into the ignition cylinder and turn to ACC position.
4. Within 5 seconds, push any button on the keyless remote. Your hazard lamps should flash. (Do not press the button more than one time in the above step). If the button is pressed more than one time, the programming procedure will not be successful.
5. If there are any remaining remotes (including the old ones), unlock then lock all doors using the driver’s side power lock/unlock switch. Within 5 seconds, push ANY button on the next remote. Your hazard lamps should flash. Repeat this step for each keyless remote (including any existing keyless remotes).
6. Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.
Done
2. Insert key in ignition and remove it from the ignition key cylinder a minimum of six times within 10 seconds. Your hazard lamps will flash if you have performed this step successfully. (Withdraw key completely from ignition cylinder each time). If this procedure is performed too fast, system will not enter programming mode.
3. Insert key into the ignition cylinder and turn to ACC position.
4. Within 5 seconds, push any button on the keyless remote. Your hazard lamps should flash. (Do not press the button more than one time in the above step). If the button is pressed more than one time, the programming procedure will not be successful.
5. If there are any remaining remotes (including the old ones), unlock then lock all doors using the driver’s side power lock/unlock switch. Within 5 seconds, push ANY button on the next remote. Your hazard lamps should flash. Repeat this step for each keyless remote (including any existing keyless remotes).
6. Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.
Done
hello,
I tried this method but after the my car flashed my key fob didn’t program. I tried the same process but now the car doesn’t flash no matter how many times I put the key in the ignition. Can someone help please?
Thread
Thread Starter
Forum
Replies
Last Post