What gear to dyno in?
#4
Registered User
Join Date: Jan 2003
Location: Where I have yet to cross another Lemans Z!?
Posts: 458
Likes: 0
Received 0 Likes
on
0 Posts
as everyone else said, the "proper" gear would be 5th. that is where you would get the most accurate numbers. but then again around here the dynos suck and read either to low or to high.
one thing I've come to realize about the dyno is just to be worried about consistency! as long as you keep your runs the same each and every time you make a mod you will have as close to accurate gains or losses to show! the end numbers might not be as high or low as your looking for but showing the differences will always be there and that is key!! if you run the 1st time in 4th for baselines stay with that EVERY time after! and same with 5th! if you keep changing up your numbers wont be as true as they should! $0.02
one thing I've come to realize about the dyno is just to be worried about consistency! as long as you keep your runs the same each and every time you make a mod you will have as close to accurate gains or losses to show! the end numbers might not be as high or low as your looking for but showing the differences will always be there and that is key!! if you run the 1st time in 4th for baselines stay with that EVERY time after! and same with 5th! if you keep changing up your numbers wont be as true as they should! $0.02
Last edited by KJ-350; 02-12-2003 at 08:46 PM.
Thread
Thread Starter
Forum
Replies
Last Post
MAsSIVrOOM
Engine & Drivetrain
2
10-20-2023 10:50 AM
Bodyboarder81
Forced Induction
13
09-21-2015 06:23 AM