Lean code and smoke?
#1
New Member
Thread Starter
Join Date: Jan 2014
Location: Central, IL
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
Lean code and smoke?
I am throwing a lean code on my bank 2, sensor 1, 02 sensor. I know I need a tune due to my spacer, tp's and k&n air filter but recently my car started puffing out blueish-white smoke if I blip the throttle sitting still, but it does not smoke at all if I go WOT. the lean code also came up recently so I'm wondering if the lean condition is causing the smoke or if something else is causing both. No vacuum leaks that I can find, and did a compression check last fall(just because), all was good there. Where do I look next?
#3
New Member
iTrader: (1)
Join Date: Nov 2012
Location: Hesperia
Posts: 255
Likes: 0
Received 0 Likes
on
0 Posts
Try erasing the code and then try disconnecting the b2 sensor1 o2.Should be 1st sensor on the drivers side header. see if it gives the same code. If so,may need to replace our o2. Let us know how it turns out.
Thread
Thread Starter
Forum
Replies
Last Post
etkms
Engine & Drivetrain
29
06-19-2022 06:30 PM
Colombo
Forced Induction
35
11-09-2020 10:27 AM
350Z Project X
Maintenance & Repair
11
10-17-2015 05:16 PM