Mounting VQ35DE on Engine Stand Bolt Size...
#1
Registered User
Thread Starter
Join Date: Feb 2017
Location: Long Island, NY
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Mounting VQ35DE on Engine Stand Bolt Size...
Sorry for the bit of a lame thread, but I couldn't find anything in my search.
Before I go about pulling my engine and realizing that the OEM bellhousing bolts aren't long enough, what bolt sizes (diameter x pitch x length) are best to mount a VQ35DE on a engine stand on the bellhousing side?
Thanks!
Before I go about pulling my engine and realizing that the OEM bellhousing bolts aren't long enough, what bolt sizes (diameter x pitch x length) are best to mount a VQ35DE on a engine stand on the bellhousing side?
Thanks!
#2
New Member
It's not too hard to take the volt to ace and get it sized and get a new bolt if need b
#3
Registered User
Thread Starter
Join Date: Feb 2017
Location: Long Island, NY
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
#4
General & DIY Moderator
MY350Z.COM
MY350Z.COM
iTrader: (64)
This is a bit on the lame side. It also depends on what the mounting stud length is on the engine stand you have. My suggestion? If it's just a cheap stand, just modify the length of the mounting stud to fit an OEM tranny bolt. That way you know you've got the right thread pitch to fit. Too long? Throw some washers on...