You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
Trying to decide how to run the wiring for my Wideband... looking for a pass-through through the floor pan into the cabin, but not finding much. Only thing I found so far is through where the steering column runs out. Is there a better place that I'm just not seeing? This is on an 03 track, if that makes a difference.
Take off your shift knob, pop off the a/c control panel and either poke a hole in the shifter boot or drill a hole in the plate that is bolted to the car.
Take off your shift knob, pop off the a/c control panel and either poke a hole in the shifter boot or drill a hole in the plate that is bolted to the car.
Ah, was looking for a pre-existing grommet. Man, there's hardly anything to pass wires through on my Z, compared to my 3000gt. I swear that thing had factory grommets everywhere.
Ah, was looking for a pre-existing grommet. Man, there's hardly anything to pass wires through on my Z, compared to my 3000gt. I swear that thing had factory grommets everywhere.
There's a large factory grommet behind the battery. Be careful with it though.
Pass-through floor panel?
