The Official Shift Knob Thread
The following 2 users liked this post by craig12895:
A-Town-Z (04-19-2016),
HRMoneyPit (04-11-2016)
The following users liked this post:
A-Town-Z (04-19-2016)
The following users liked this post:
Desert Z (01-14-2017)
#449
New Member
iTrader: (2)
Got mine from WC Lathe Werks. Stainless Piston Gunmetal Leather Wrapped Shift **** with Orange Stitching. So much heavier than stock. Loving the feel. The customization available for it was a definite selling point over the TWM shift ****. Did take almost half a month to get to me, but definitely worth it.
#450
New Member
iTrader: (1)
Decided it was time for a change...went from this:
A6 Leopard from TMW:
To this Desert Eagle also from TMW:
Love the look and it's nice and heavy but it's taking some getting used to...very different feel from the ball shape of the Leopard. All good though. :thumb up:
Shawn
A6 Leopard from TMW:
To this Desert Eagle also from TMW:
Love the look and it's nice and heavy but it's taking some getting used to...very different feel from the ball shape of the Leopard. All good though. :thumb up:
Shawn
Last edited by SPM350Z; 06-10-2018 at 07:46 PM.
The following users liked this post:
HRMoneyPit (01-14-2017)
#453
Registered User
The following users liked this post:
guitman32 (06-19-2018)
#458
Old thread I know.... I'll probably get flamed here, but would anyone be interested in a **** like this? I'm thinking of doing a run of 10. I realize this isn't a group buy forum.... I'm simply curious if there's any interest out there.
I've always wanted a super heavy shift ****, as I really like how a heavy **** feels when shifting. I also like a raw metal finish. But there's nothing available out there in shape I like. So I figured I'd make my own.
It will be very expensive..... but totally unique, and extremely heavy - over 1lb.
If anyone is interested, pm me.
note: it wouldn't have lines on it... those are just from the drawing
I've always wanted a super heavy shift ****, as I really like how a heavy **** feels when shifting. I also like a raw metal finish. But there's nothing available out there in shape I like. So I figured I'd make my own.
It will be very expensive..... but totally unique, and extremely heavy - over 1lb.
If anyone is interested, pm me.
note: it wouldn't have lines on it... those are just from the drawing
Last edited by TSelanne; 08-20-2021 at 10:10 AM. Reason: content
#460
350Z/370Z Tech Moderator
MY350Z.COM
MY350Z.COM
I'm not into metal shift ***** though. I had one on my Shiro that was so hot from sitting outside that I could barely touch it. Love me some good leather. <===Read that as you will. Laff.....