2007+ OEM hood?
#21
Master
iTrader: (8)
okay, so i put a board on top of the engine cover right behind the strut bar, and another resting on the bolts holding the front of the engine cover on and resting against oil dipstick. i put painters tape on the body line and measured at the highest point of the fender (and i think the fenders are the same for all years)
this is the rear one
this is the front board
was a pain to get up there
this is the rear one
this is the front board
was a pain to get up there
Thread
Thread Starter
Forum
Replies
Last Post