Thinking of doing some vinyl wrapping. How would this look?
#1
Registered User
Thread Starter
Join Date: Jan 2015
Location: Delco PHL
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
Thinking of doing some vinyl wrapping. How would this look?
Might do the pillars in gloss black vinyl.. what do you guys think?
(PS: if someone has better photoshop skills than me and would like to glossify my job, feel free.
Im sure people have done the pillars like this before, any one have pics/know where to find them?
(PS: if someone has better photoshop skills than me and would like to glossify my job, feel free.
Im sure people have done the pillars like this before, any one have pics/know where to find them?
#2
New Member
iTrader: (7)
Ive never had anything wrapped before, but I think the issue you would have with that would be that the vinyl will be cut mid way up the pillar. Meaning that at some point there will be a ledge where the vinyl will stop. Im not sure how strong the vinyl is or if that would start to pick up after time.
#3
Registered User
Thread Starter
Join Date: Jan 2015
Location: Delco PHL
Posts: 115
Likes: 0
Received 0 Likes
on
0 Posts
hmm, good point. If i did do the vinyl, i'd wrap it under the bottom panel edge and heat shrink it to the panel.. I may just do a coat of gloss plasti dip to see if I like the new lines.
#7
Registered User
Join Date: Dec 2014
Location: Roanoke Va 24012
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
I wrapped a Dash and the tops of the doors on a little Ford Pickup.It turned out very nice.If you use the Primer that they recommend it should go great.You can wrap it with vinyl that looks like Carbon fiber also.
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM
350Z Project X
Suspension
9
10-10-2015 09:23 AM