SilverStone2003

iTrader: (3)

Sooooo Im not getting any help on myg37, figured it wouldnt hurt to ask here.

Specs BC BR Type Coilovers, Kinetix suspension arm package from Z1.

I have the fronts maxed out and after the suspension settled im sitting on just the bumper, no big deal I plan on raising it about a half inch.

Question I have is the rear, I have them completely maxed out and im still looking at about a 3/4-1in fender gap. What exactly am I going to have to do in order to close that gap.

Didnt have this problem with the BC coils on my Z what so ever. I'm faily certain I ordered and dropped the car "the right way" with the controls arms and what not.


Thanks in advance for any help/advice. Im going to post a picture for reference in a few minutes.

SilverStone2003

iTrader: (3)

This is all I have for picture references right now. Hopefully you can see the rear gap im referring to.

SilverStone2003

iTrader: (3)

Bump, nobody??

blnewt

IIRC BC changed the rear springs to slightly taller ones since the original shorter springs were dropping too low at even their highest settings. Might check w/ BC to confirm though.

SilverStone2003

iTrader: (3)

I'm thinking maybe I dont have them set properly? Everyone I've talked to Vendors, and guys who have these coils on Z's and 240's say that theres basically dump the rear. A few vendors I've spoken with have told me that I can special order a set of shorter springs, but I'd rather not go the route of removing the coils again to install the shorter spring.

Is there a special way of adjusting the rear im not aware of? Even in my pictures it doesnt look "right" to me.

terrasmak

iTrader: (8)

Without pics, it's hard to say.

Are you sure that you are not bottoming out the shock ?

SilverStone2003

iTrader: (3)

Im gunna pull the rear wheels off and post a picture of the coil over itself when I get in from work. But Im quite sure it isnt bottoming out on the shock.

I get 0 help over on myg37.