TP rattling
#22
Got under the car and all I can say is it's coming from the test pipes. Can't tell if it's where it meets the headers or where it meets the y pipe. I took the cat brace off to see if it got worse and nothing changed. Tightened everything to make sure the gaskets are fully contacting with the pipes and no change of that rattle noise. Kinda disappointing that no one has a fix for this and no company can garuntee a pipe that is rattle less.
#29
Registered User
iTrader: (2)
Join Date: Jan 2010
Location: South Bend, IN. USA
Posts: 345
Likes: 0
Received 0 Likes
on
0 Posts
I used to have Berk's test pipe with Greddy Evo2 catback exhaust setup. It was rattle at low rpm because the Greddy was so dame heavy it hang down and hit the subframe under brace. Ever since I have new LTH and full exhaust setup, I have yet hear the rattle noise again. So, I am certain the rattle noise causes by two metal objects is hitting or rubbing against.
#32
Registered User
Nate350, you have to think about how mufflers and resonators suppress sound levels. Modern units are pretty free flowing, however they create an environment where some sound waves escape the main flow, bounce off chamber walls, and then rejoin the primary wave. This becomes a situation where the two waves are of the same amplitude, but are out of sync and will cancel each other out silencing the roar.
In addition to tuning for this reaction an exhaust system must also deal with the fact that each time an exhaust valve opens a slug of high-speed air rushes through the system. This creates high air pressure in front of the air and low pressure behind it. Maintaining the flow of low pressure through the system is a primary concern of engine tuners as this will help scavenge exhaust from the next cylinder to exhaust and so on.
As you can imagine, tuning an exhaust system to work over all throttle ranges and all RPMs is much like tuning a musical instrument. Your stock system’s tuning accounts for the mass of the cats. By switching them to flimsy little test pipes you are getting some of the pressure pulses banging into each other at certain rpm/throttle positions. This can create the raspy/rattling sounds you are hearing.
In addition to tuning for this reaction an exhaust system must also deal with the fact that each time an exhaust valve opens a slug of high-speed air rushes through the system. This creates high air pressure in front of the air and low pressure behind it. Maintaining the flow of low pressure through the system is a primary concern of engine tuners as this will help scavenge exhaust from the next cylinder to exhaust and so on.
As you can imagine, tuning an exhaust system to work over all throttle ranges and all RPMs is much like tuning a musical instrument. Your stock system’s tuning accounts for the mass of the cats. By switching them to flimsy little test pipes you are getting some of the pressure pulses banging into each other at certain rpm/throttle positions. This can create the raspy/rattling sounds you are hearing.
Thread
Thread Starter
Forum
Replies
Last Post