Header Wrapping
#2
350Z-holic
iTrader: (13)
Its gonna depend on (obviously) on the headers but I think you'll be fine with 50 feet per header. There is a 'calculator' on DEI's website you should check out -
https://www.designengineering.com/ni...wrap_calc.html
I would go with 1" width if you can for tighter radius runs and the 2" width for straight runs. So two rolls of 1" and a roll of 2" would be good.
I would also ditch the metal zip ties and buy a roll of rebar tie-wire to secure the wrap. It's $10-$15 at lowes/home depot. I'll post a picture of what I did.
https://www.designengineering.com/ni...wrap_calc.html
I would go with 1" width if you can for tighter radius runs and the 2" width for straight runs. So two rolls of 1" and a roll of 2" would be good.
I would also ditch the metal zip ties and buy a roll of rebar tie-wire to secure the wrap. It's $10-$15 at lowes/home depot. I'll post a picture of what I did.
Last edited by bealljk; 03-28-2015 at 08:18 PM.