FS: Custom 3.5" polished short ram intake kit
#1
Registered User
Thread Starter
iTrader: (7)
Join Date: Sep 2007
Location: Bay Area, CA
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
Custom 3.5" polished short ram intake kit
Asking $100 shipped to lower 48 states
Intake will include couplers and polished clamps you see in the pic
I had this installed with my NWP Big Bore throttle body so the coupler on the throttle body side is meant for the 75mm opening. You'll need a reducing coupler like the one on the other end of the intake if you wish to run it with an OEM throttle body.
It has a couple of small nicks. I can provide additional pictures if desired.
No filter is included. This intake sits between your throttle body and MAF housing, same as OEM.
There is no vacuum port on it as well on the backside. You'll want to add a filter to the back of your drivers side valve cover (see 1st pic below) where normally a vacuum/breather hose would come out and connect to the oem intake.
PM if interested
Thanks
Intake will include couplers and polished clamps you see in the pic
I had this installed with my NWP Big Bore throttle body so the coupler on the throttle body side is meant for the 75mm opening. You'll need a reducing coupler like the one on the other end of the intake if you wish to run it with an OEM throttle body.
It has a couple of small nicks. I can provide additional pictures if desired.
No filter is included. This intake sits between your throttle body and MAF housing, same as OEM.
There is no vacuum port on it as well on the backside. You'll want to add a filter to the back of your drivers side valve cover (see 1st pic below) where normally a vacuum/breather hose would come out and connect to the oem intake.
PM if interested
Thanks
Last edited by Gpapa; 11-16-2016 at 03:15 PM.
#4
Registered User
Thread Starter
iTrader: (7)
Join Date: Sep 2007
Location: Bay Area, CA
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts