TriniSpec

Whatsup guys, i'm about to buy a Z as a winter project. I am wondering why the shifter is so low picture below, I know thats not a SSK. .Or is it Maybe someone can offer some insight about this problem, i was thinking it could be a transmission mount. Has this happened to anyone around here? The car is hit fairly hard, frame is straight. Thanks, any insight would be appreciated



Thanks guys

ian99rt

iTrader: (12)

Well a failed OEM bushing would not allow the shifter to drop that low.

The fact its centered, I'm guessing the transmission isn't supported and is just hanging.

midz350

iTrader: (4)

Why don't you look under the car and see for your self?

TriniSpec

The car is not in my possesion ATM.

silvertouringz

in for more pics

JCITY

iTrader: (2)

Just install a longer shifter!
No,just kidding.
The shifter is sitting so low I'm surprised its not on the ground.
Obviously,just hanging there.

TriniSpec

As for pics the front end is pretty f*cked up.

That damn plastic cover is blocking the intake plenum so I can't quite tell if the motor mounts broke and the engine is pushed back. I was trying to judge where the strut bar goes across the intake plenum, but I can't really see ****.


I'm no Z expert, but judging where the oil filler cap SHOULD be, looks like the engine is pushed back, correct me if i'm wrong.

The actual car, yes it's an insurance auction..


It's a 03, both front airbags blown, the frame horns may need pulling as the bumper support is damaged..

TriniSpec

I'm thinking I should walk away from this, looks like the engine is pushed back into the firewall, judging from other Z's.

This Z has a pretty significant gap between the I/M and the firewall.

Cux350z

iTrader: (162)

RUN!

Why would you even want to bother with rebuilding that?

That car is so messed up.

RandomHer0

iTrader: (9)

Jesus, walk away dude.

terrasmak

iTrader: (8)

you better get that for under $2k if you buy it.

TriniSpec

Possible theory, transmission crossmember support thing broke tilting the shifter way down and also tilting the engine back. I'm trying to look at this on the bright side, airbags for the 350Z also aren't cheap. Car is selling tomorrow, i'll try to get into it for cheap. BTW, the car has 105k miles on it.

silvertouringz

the engine IS pulled back! the strut bar shoulf be over the plenum which is not. u can get less damaged cars. which site r u looking on?

djamps

iTrader: (1)

Engine is almost a foot back from where it should be. shifter linkage is probably severed and the stick is just holding on by the boot. You sir, have big bawls if you plan on fixing this.

La_Fiebre

konrad

iTrader: (15)

If you want a g35 coupe as a project there is one in NJ front and rear damage , but a lot better than this , for $3400 03 6mt

Shizzmaster2k

iTrader: (7)

On to the next one. High risk. Low reward with this Z but there is always potential if your crafty with the tools and plan to turn this into the next big DIY project. Good luck OP!

bmccann101

iTrader: (16)

^^^this is why the internet was created..
im going to p!ss my pants dude.

Heritage

iTrader: (3)