Replaced Window Motor + still not working _SEARCHED_

[skunk281]

I just replaced my drivers side window motor and will be replacing my pass motor if i can get an answer or suggestion.
But after replacing the drivers side i put everything back and it still doesnt work.
I apply the switch and it clicks but no movement i dont even here a hum of the motor like if there was electricity going thru.
Even connected the new pass motor and nothing so i dnt think its the motors.
Oh and i even tried the reset.
Help any is useful!
Thanks!

[ms350z]

Did you check page 14 of the sticky about replacing the window motor where somebody mentioned bent pins in the connector?

[skunk281]

Yep.

Tried what jay z has described and nothing still.

Installed the new pass motor and everything is fine i can even roll it up from the main switch. The drivers side however still wont budge!
I connected the new drivers side motor nothing pass side motor on the drivers side nothing.


Sooo heres what i think maybe be wrong.

Main drivers side window switch circuit looks burnt.

What do you all think?

[ms350z]

I concur, that circuit is burnt, glad you found the problem!