Trunk light bulb stopped working??? /fuse fix
#1
Registered User
Thread Starter
Trunk light bulb stopped working??? /fuse fix
Originally, the trunk light in my 03' 350z had a cool white LED bulb in it. It wasn't bright enough to my liking, so i went and bought a super bright LED bulb from superbrightleds.com. As soon as I go to remove the older bulb and install the new one, it wouldn't light up at all even though it fit perfectly; nice and snug. So I go to try and put the older bulb back in, and that DID NOT light up either. Tried turning the ignition over to see if that would do anything, nothing... I tried unplugging and plugging the connector back in to see if that will do anything, and it still didn't light up. Any suggestions as to why this stupid issue came up?? -__-
#3
New Member
Old one no longer works?
I'm guessing you blew a fuse.
I'm guessing you blew a fuse.
#4
Master
iTrader: (8)
this... i learned that after beating my head on the wall for a couple hours
i would contact diode dynamics, they are a vendor on here
http://www.diodedynamics.com/store/
i would contact diode dynamics, they are a vendor on here
http://www.diodedynamics.com/store/
#5
Registered User
iTrader: (15)
Have a look at this one - best and brightest you'll find:
http://zledslights.com/order-now/#!/...tegory=6624014
I've got one in my '08, as well as the dome lights:
http://zledslights.com/order-now/#!/...tegory=6624014
http://zledslights.com/order-now/#!/...tegory=6624014
I've got one in my '08, as well as the dome lights:
http://zledslights.com/order-now/#!/...tegory=6624014
#7
Registered User
Thread Starter
Trending Topics
#9
Registered User
Thread Starter
After searching for hours, I found the third fuse box underneath the steering wheel. Trunk light fuse (10 amp) was there and was blown. swapped the fuse and the light started working again
#10
New Member
#11
Obviously if it's blown I'll see which one it is of course
Ignore that - just realised it should have a sticker in there but if not:
https://my350z.com/forum/maintenance...use-panel.html
Last edited by RobPhoboS; 03-23-2015 at 05:03 AM.
#12
I used my multimeter i got reading of 11.2v and the trunk light is not turning on.
When I ignite I got 14.1v and still bulb is not on.
and I used other powerbank with 12v output and was the light is working.
my scenario what could be wrong i even tried to reverse (+ and -) the bulb and attached still didn't work
its supper unknowing why its not working
individual tested
1.bulb work with powerbanks 12v and not work with car trunk wires
2. Getting power in the socket all the way till where I connect the bulb in the trunk wire
Thread
Thread Starter
Forum
Replies
Last Post