driver side window malfunction....
#1
Registered User
Thread Starter
driver side window malfunction....
Hey guys, thanks ahead of time.
My driver side window does:
1. Does Not go all the way up with one push
2. Does not go down unless I hold the button and shut the door
3. Does not "synch" shut when the door is closed to reduce wind noise
Also, when the window is going up it sounds like it is struggling to do so.
Is my motor going?
Easy fix or go to the dealer???
My driver side window does:
1. Does Not go all the way up with one push
2. Does not go down unless I hold the button and shut the door
3. Does not "synch" shut when the door is closed to reduce wind noise
Also, when the window is going up it sounds like it is struggling to do so.
Is my motor going?
Easy fix or go to the dealer???
#2
General & Tech Moderator
MY350Z.COM
MY350Z.COM
You don't say year or miles so
1) search "window reset/relearn"
2) if that fails take the motor apart and clean inside w CRC electronics cleaner.
3) if that fails replace motor and perform reset.
It's not hard, my cleanup has lasted 2 yrs. Do some homework, gl
1) search "window reset/relearn"
2) if that fails take the motor apart and clean inside w CRC electronics cleaner.
3) if that fails replace motor and perform reset.
It's not hard, my cleanup has lasted 2 yrs. Do some homework, gl
#4
General & Tech Moderator
MY350Z.COM
MY350Z.COM
As the brushes wear down they leave a carbon dust all over the inside. Kinda causes shorting/voltage drop on the armature. You gotta get that dust out. It's not hard, I would nvr pay for this repair. Take the door pull off then inside panel and you're there.
#5
Registered User
Thread Starter
I did a little research and found some decent articles on motor replacement. I will buy a motor ahead of time so that if it is needed I will have it. Once I have done the repair I will post up. thanks
#6
General & Tech Moderator
MY350Z.COM
MY350Z.COM
Smart man. Prolly just put new 1 in since some places don't accept electric returns?
#7
Registered User
Thread Starter
Yeah, I will more than likely just replace it once I strip down the door. I would rather do that than have to go back in there because a cleaning didn't do the trick
Thread
Thread Starter
Forum
Replies
Last Post
Gruppe-S
Body Interior
13
05-16-2016 10:42 PM
ars88
Zs & Gs For Sale
18
04-04-2016 07:52 AM
CFAUVEL
Exterior & Interior
3
10-01-2015 03:20 PM