jzk91

iTrader: (1)

hi, so i had problem engaging gear while engine running, and did master and slave cylinder replacement, but today at shop, they figured its throw out bearing that caused problem. and they said it seems like my clutch wasnt properly contacted flywheel, since they saw hot spots, and printing of name on clutch disc is partly removed. this kit was installed 4 month ago with pivot bearing, throw out bearing and pressure plate and clutch disk. because of the problem, shop is saying i will need resurface the flywheel and basically new clutch kit. is there any way i can reuse clutch disk and pressure plate with just resurfacing the flywheel? and can nonresurfaced flywheel can cause such a problem like this?