New Owner: 2002 firelady z
#1
Registered User
Thread Starter
New Owner: 2002 firelady z
Hello,
My name is Avtanil, I live in Georiga and I have JDM firelady z
I have lot of questions about this car and hope I will get answers here.
little modes:
intake plenum spacer.
2.5 cat less downpipes.
Fujitusbo Legalis exhaust system.
Before Z I have owned cars:
Toyota Celica GT-Four 1995 - 260WHP
Legacy GT 2.0 turbo 2006 - 256WHP
when I tried to test my z on dyno, I got speed limit, So I was not able to test my car on 5th gear (1x1 ratio). on 4th gear power was 247whp 350nm.
as you can see my z is slower than my previous cars, so what I am going to do is to start turbo project. for this I need lot advices , I am sure, that here is many experienced people in this case
this is my car:
Sorry for my English
My name is Avtanil, I live in Georiga and I have JDM firelady z
I have lot of questions about this car and hope I will get answers here.
little modes:
intake plenum spacer.
2.5 cat less downpipes.
Fujitusbo Legalis exhaust system.
Before Z I have owned cars:
Toyota Celica GT-Four 1995 - 260WHP
Legacy GT 2.0 turbo 2006 - 256WHP
when I tried to test my z on dyno, I got speed limit, So I was not able to test my car on 5th gear (1x1 ratio). on 4th gear power was 247whp 350nm.
as you can see my z is slower than my previous cars, so what I am going to do is to start turbo project. for this I need lot advices , I am sure, that here is many experienced people in this case
this is my car:
Sorry for my English
Last edited by superhardware; 03-31-2016 at 02:46 AM.
#4
New Member
I've always wanted to visit Tblisi. Welcome to the forums, and good on you for picking red.
#5
Registered User
Thread Starter
my project gone be cheaper in z history
I am not going to buy Graddy kit.
I am thinking to make some fabrications myself.
+td04 From subaru (2 x 150USD).
this is my garage:
https://www.facebook.com/Geochipmaker/?fref=ts
I milling, lathe, tig, everything, what is need to buit turbo kit.
So without ecu + tuning I can offer turbo kit for 1000USD (after mine will compete)
Can anyone give thread link of this site, were is aftermarket ecu discussion??
Cant decide what type of ecu I need...
I am not going to buy Graddy kit.
I am thinking to make some fabrications myself.
+td04 From subaru (2 x 150USD).
this is my garage:
https://www.facebook.com/Geochipmaker/?fref=ts
I milling, lathe, tig, everything, what is need to buit turbo kit.
So without ecu + tuning I can offer turbo kit for 1000USD (after mine will compete)
Can anyone give thread link of this site, were is aftermarket ecu discussion??
Cant decide what type of ecu I need...
Last edited by superhardware; 04-01-2016 at 03:43 AM.
The following users liked this post:
superhardware (04-11-2016)
Thread
Thread Starter
Forum
Replies
Last Post
trentor
Meet-Ups / Events (Texas)
3
08-23-2011 11:56 AM