ZEX TPS Trigger
#42
Registered User
iTrader: (3)
Join Date: Mar 2011
Location: Carmel, Indiana
Posts: 228
Likes: 0
Received 0 Likes
on
0 Posts
thanks that helps alot.. im just going to cut it instead of tapping it and install two clip on connectors (male and female) and then clip it together. just put 2 wires into one of the connectors.
#44
Registered User
iTrader: (3)
Join Date: Mar 2011
Location: Carmel, Indiana
Posts: 228
Likes: 0
Received 0 Likes
on
0 Posts
well **** lol, i dont have a solder gun or pen.. really dont want to buy one either, im not oging to use the thing that you used cause they tend to dig into the wire over time and break
#47
Pic 1:
That's the wiring for the coilpack for cylinder one (passenger side, closest to front bumper). Find the red striped yellow wire and tap into that for your RPM signal.
Pic 2:
That's the wiring for your throttle body. Find the green wire and tap into that for your TPS signal (voltage).
That's the wiring for the coilpack for cylinder one (passenger side, closest to front bumper). Find the red striped yellow wire and tap into that for your RPM signal.
Pic 2:
That's the wiring for your throttle body. Find the green wire and tap into that for your TPS signal (voltage).
Any ideas?
#49
Registered User
Join Date: May 2020
Location: Pennsylvania
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Has anyone ever tapped into the ECU for this? I was told you can. However i was not successful. I should now go to the Green wire at the throttle body? (03 350z)
Thanks.
Thanks.
Thread
Thread Starter
Forum
Replies
Last Post
NOLAGG
Misc.
6
09-28-2015 04:14 PM