FS: Rear Spring Mounts Precut 3/4" Even Height
#1
Rear Spring Mounts Precut 3/4" Even Height
I have a set of precut rear spring mounts that came off of a 2008 350Z. They are cut 0.75" and lower the rear exactly that.
Save time on cutting and avoid down time if you buy these. You can keep your stock ones for backup or sell them to recover the cost of these.
I am selling these because I have a new setup and want to recoup the cost of my new setup.
Only $40.00 plus $7 shipping!
Save time on cutting and avoid down time if you buy these. You can keep your stock ones for backup or sell them to recover the cost of these.
I am selling these because I have a new setup and want to recoup the cost of my new setup.
Only $40.00 plus $7 shipping!
#3
New Member
iTrader: (93)
I bought a set to mod when I had my 19" GTS on there but the 275s filled the wheel well up nice enough. Then I got 18x10.5 square RPF1s and they were sunk with almost 3 finger gap. 10mm spacer and cut mounts later... like a bawws
GLWS!!!
#4
Thanks. Yeah, I notice a lot of people cutting their springs lately. After all, it is much easier to dremel away a coil to hacksaw a rubber spring mount.
I can do $35 shipped if anybody is interested. I really want to recover the cost of my new springs.
I can do $35 shipped if anybody is interested. I really want to recover the cost of my new springs.
Thread
Thread Starter
Forum
Replies
Last Post
Lt_Ballzacki
Brakes & Suspension
39
08-06-2021 06:19 AM