When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
After an hour of fussing with a seized end link, finally got the rear anti roll bar up. Went to put the exhaust back up, and too my surprise. IT DON'T FIT!! Modification here I come!
After an hour of fussing with a seized end link, finally got the rear anti roll bar up. Went to put the exhaust back up, and too my surprise. IT DON'T FIT!! Modification here I come!
Did you put it above the sway bar or did you put it below the sway bar and fight with it for an hour wondering why it wouldn't fit like me?
Yeah mine goes above the sway bar... It doesn't bolt together like yours so I have endless ways to try getting it on... I was so frustrated I almost just left the rear muffler off...
If you 180 that pipe and go above its a no go? What exhaust system is that?
Mine has slip joints fits really close to the differential ears, and the spring bucket but has lots of sway bar clearance.
It's an Invidia Gemini. I'm thinking I'm gunna try a heat and beat. If that doesn't work I'm going to cut it and put a piece of flex pipe on it so I can get to the track this weekend
oh.... i had that exhaust, it does go over it. you need to rotate it 180 degrees. if it wont go over the sway that way.... flip it, if still no go, rotate it 180 degrees again. it will fit both ways, but supposed to go over the sway
and also... i believe the left and right pipes will go on the opposite side.. it may be that you have the wrong pipe on the opposite side. the drivers one is more straight and the passenger has a bend for it to go over the bar
Followed some DIY's and replaced the non-existent brushes in my driver's window motor. No more going all Mortal Kombat on my door to make my window work!!!!
It sounds so much stronger. Going to do the passenger side too for insurance. Not a bad way to spend an hour and $5.00!
and also... i believe the left and right pipes will go on the opposite side.. it may be that you have the wrong pipe on the opposite side. the drivers one is more straight and the passenger has a bend for it to go over the bar
Well fudge me, i didn't know or even try that. ROFL, and obviously didn't check my messages! I went the impatient heeman route. but its in there now!
I damn I was hoping you would check back... I understand the frustration though. I was 100% ready to remove my dual exhaust and put my cheesy single back on...
I damn I was hoping you would check back... I understand the frustration though. I was 100% ready to remove my dual exhaust and put my cheesy single back on...
Yeah, i was getting anxious, and my last new end link was delivered this morning allowing me to finish her and be ready for the weekend. I almost shed a tear after the first few hits. Then I said F it. Ill fix it in the winter!!
09-25-2016, 05:27 PM
