Long tube headers
#1
Registered User
Thread Starter
Join Date: Jul 2014
Location: Boston, MA
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
Long tube headers
Hey guys. I just bought some long tubes from ISR. My factory o2 sensors do not reach. Is there anyone that sells extenders. Or had anyone cut and added wire to their o2 sensors to make them longer?
#3
Super Moderator
MY350Z.COM
MY350Z.COM
iTrader: (8)
I had to cut and solder for my PPE header install
#5
Registered User
Thread Starter
Join Date: Jul 2014
Location: Boston, MA
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
As figured everyone’s answer was about the same about extending. I plan on extended it myself. Should I extend it from the sensor or cut the engine wiring harness and extend that?
#6
6 inch cawk is my fave!
iTrader: (3)
I would extend the sensor side, once you cut your harness theirs no going back.
I used some crazy box connection on mine, if I remember correctly they need some air flow around then or something.
Don't know if you can tell from the pic but theirs some big *** box connectors on my 02 sensor wires.
I used some crazy box connection on mine, if I remember correctly they need some air flow around then or something.
Don't know if you can tell from the pic but theirs some big *** box connectors on my 02 sensor wires.
Trending Topics
#8
Registered User
Thread Starter
Join Date: Jul 2014
Location: Boston, MA
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
This is what I used.
https://youtu.be/ex1Hki6-NHw
https://youtu.be/ex1Hki6-NHw
sounds good. I assume cutting the engine wiring harness would be bad and it would be better to cut the o2 sensor and extend the wires!
Thread
Thread Starter
Forum
Replies
Last Post
VQ35DES
Intake Exhaust
26
10-07-2003 02:50 PM
MY350Z.COM
Intake Exhaust
3
07-31-2003 06:24 PM