Three-way set up with Nazar's pods anyone?
 

Has anyone done one before? I was wondering what you used for crossover points?

I ask because:

I just started my 3-way setup with Nazar's pods!

I have a set of a/d/s 2 way 5.25inch components in my kicks as seen here:
http://img146.imageshack.us/img146/6968/p1000533oq4.jpg

Pardon the carpet on the kick panels. Until today I could not find anyone who wouldn't turn up their noses to custom work. :rolleyes:

I have had a hell-of-a time finding some orion HCCA or a/d/s old school 6.5s so I just went with a current line of speakers: Kicker ssmb6 ...6.5 inch midbass drivers. I have heard good things about them so lets hope they don't disappoint.

Unless I'm misunderstanding the post, the pods wouldn't have anything to with crossover points. Contact the manufacturer of the speakers and they may be able to get you some good starting points.

I can give you what DLS gave me for the 6.3i's, but I'm not sure that would do you much good.

I have a 4 channel and the 2 way components with the two way passive crossovers are powered off the front channels and the single set of midbass drivers will be driven off the rear channels with no passive crossover.

The phoenix gold xenon 200.4 has a bandpass filter meaning I can turn the low pass and high pass filters on and narrow down the frequency range I want to play.

What did DLS say? I am just curious.

Got it. :)

I'm running fully active but here is where DLS told me to set my x-overs.

X over points for IR 6.3

IR 6.5 60-315 hz
Slope HP 12db/oct
LP 24db/oct

IR 3 315-4500hz
HP 24db/oct
LP 24db/oct

IR 1 +4500hz
HP 24db/oct

cool thanks. I may start there and see how it goes.

How do you have yours mounted?