Finally finished my install! JL 10w3v3's + DLS Amps/UX26 Coaxial
 

I have been buying components to my install for the past few months. It started with a ZEnclosure for 2 "10 woofers. I couldn't decide what subs to buy, but found a pair of JL Audio 10w3v3's on Ebay for about $350 and went with those. Also picked up a Clarion head unit for $215 on ebay. Then Bing came along. He helped me pick out two affordable DLS amps and some DLS UX26 Coaxial speakers. I sent him my stock kicks and he designed them + installed the speakers and sent them back to me. Just got everything installed Monday-Tuesday. Thanks to Bing and Mr T's Auto Craft in Dayton!!! Everything sounds amazing! Subs are hell of lot louder than I expected, almost too much for me really..

For those that don't want to read...
- JL Audio 10w3v3's
- ZEnclosure
- DLS two channel + mono D amps
- DLS UX26 Coaxials
- Kicks built by Bing - They match perfectly, bad lighting in pics!
- Clarion DXZ775UB - May change soon

View 2 x 3 Pictures

http://img2.putfile.com/thumb/8/23821153048.jpg http://img2.putfile.com/thumb/10/30318115031.jpg http://img2.putfile.com/thumb/10/30318115162.jpg
http://img2.putfile.com/thumb/10/30318115129.jpg http://img2.putfile.com/thumb/10/30318115143.jpg http://img2.putfile.com/thumb/10/30318115166.jpg

I'm looking at the pics, and I think I might see at least the lower part of the dead pedal. Can you put your foot on the dead pedal with Bing's kick pods?

--Spike

Looks like the dead pedal was removed. IDK if that's required, but it was def. done here.

dead pedal has to be removed. I got mine about 2 weeks ago. I had been waiting for a bit and for about 2 weeks i drove without using the dead pedal just to get used to it. Now that they are installed i dont miss it one bit.

good to hear :_) no way to keep the deadpedal on the Z, i mean you can mold around it, but wtih a 6.5" two way, it would block off the deadpedal anyway, not to mention decreased airspace inside it :)

if you are deteremined not to loose the deadpedal, there is always hte route of moving all the harness, plasma cut a hole into the cabity back there and mold into it :)

b

Yeah, I don't miss the dead pedal.. I have to get use to it though, already kicked it a few times.. good name being "kickers" and all. Love the way it sounds though, thanks again Bing!

they make 1.5" DIAMETER RUBBER GROMMETS
buy 2 each

slide them over you male end bolts were dead pedal was removed

provides a better finshed look on drivers side

and hides and or covers errect bolts

than your sraight money

i did it and looks great