LED's in the Door Handle's. (56k Maybe)
#24
here's how to wire them to the map lights.
first of all, you need to drill the holes, epoxy the LEDs, wire them with the corresponding resistor, then run the wires from the door handle inside the door, out through the gromet for the door, under the side skirt, under the weather stripping along the bottom of the door, up the side molding, all the way up to the headliner through the A-pillar, then over to the map lights. one tricky thing i ran into was getting the wire under the headliner over to the map light housing. i had to get a coat hangar and push it through were the light housing popped out to the windshield. then taped the wire to the hangar, and pulled it back through. here are the pics for access to the light housing, and soldering the wires.
here is where you need to pop out the lense.
first of all, you need to drill the holes, epoxy the LEDs, wire them with the corresponding resistor, then run the wires from the door handle inside the door, out through the gromet for the door, under the side skirt, under the weather stripping along the bottom of the door, up the side molding, all the way up to the headliner through the A-pillar, then over to the map lights. one tricky thing i ran into was getting the wire under the headliner over to the map light housing. i had to get a coat hangar and push it through were the light housing popped out to the windshield. then taped the wire to the hangar, and pulled it back through. here are the pics for access to the light housing, and soldering the wires.
here is where you need to pop out the lense.
#28
here is a close up of the wiring for the left side. since LED's are polar, the electricity has to flow one direction. so when doing this, make sure that positive lead wire that is connected to the resistor, then the positive lead on the LED, is soldered on to the bulb lead that is closer to the front of the car. this is very important. if you sodler the leads on to the wrong bulb connections, the LED's will not work and, if enough voltage flows through, could damage the LEDs.
#30
Registered User
iTrader: (2)
Join Date: Sep 2003
Location: Hamilton N.J
Posts: 198
Likes: 0
Received 0 Likes
on
0 Posts
First off i really like it!
Im not sure about you Z folks but i know in the G there is a light in the door "step light" that comes on with the dome light at a unlock.. If you have the same light it would save a ton of work running those wires to the dome.
Im not sure about you Z folks but i know in the G there is a light in the door "step light" that comes on with the dome light at a unlock.. If you have the same light it would save a ton of work running those wires to the dome.