HOW2: Remote Key Fob Programming
 

1. Close and lock all doors with the driver’s side power lock/unlock switch.

2. Insert key in ignition and remove it from the ignition key cylinder a minimum of six times within 10 seconds. Your hazard lamps will flash if you have performed this step successfully. (Withdraw key completely from ignition cylinder each time). If this procedure is performed too fast, system will not enter programming mode.

3. Insert key into the ignition cylinder and turn to ACC position.

4. Within 5 seconds, push any button on the keyless remote. Your hazard lamps should flash. (Do not press the button more than one time in the above step). If the button is pressed more than one time, the programming procedure will not be successful.

5. If there are any remaining remotes (including the old ones), unlock then lock all doors using the driver’s side power lock/unlock switch. Within 5 seconds, push ANY button on the next remote. Your hazard lamps should flash. Repeat this step for each keyless remote (including any existing keyless remotes).

6. Turn the key to the OFF position, remove keys from the ignition, unlock doors using the driver’s side power lock/unlock switch and open the driver side door.

Done

what does this do?

programs keyfob remote

hahah lol. Pretty much what the title says:rolleyes:

program it to do what though?

To make a master remote so you can unlock any Nissan :)

I'm assuming its if you bought a new key fob and you want to program the lock/unlock buttons.

Some dude on Ebay is charging for this info. Thank you!

Yes, but eBay is full of idiots ;)

curious question for this. If you use a key fob from your car and program it to someone elses car. How do you get it to just unlock the new car.

I gave a friend of mine one of my key fobs and i programmed it for his car. Now it unlocks and locks mine and his car

:icon18: Unleash the ICBM arsenal. What did you think it could be for?

anybody??

Freebie!

so we can buy an altima FOB, cut out the key for the Z, and program it to open the Z in this way?

^You can only program the FOB when using a programmed key. Every Z key has a small micro chip that is registered to your cars computer. When inserting the programmed key it allows you to program any new FOB to your cars computer. A access of sorts.

does it matter if you have aftermarket remote control?

so, in other words it means that even if i get a an un-cut Altima key, i can't actually cut it to be used on my Z??

i was actually about to buy the new Altima's key fob, but now i'm not sure if this gonna work or not.. :confused:

someone shed some more lights plzz..

i just bought the new altima key fob. i'll update u if i were able to do anything about it.
http://blogs.edmunds.com/.ee98b88/cm...osure..ee98b89

from a pretty reliable source who works for Nissan in MS... it's not gonna work.. TOTALLY different system... good luck trying though

this is to confirm for all, it won't work.. tried it couple of times, no luck.

i'm gonna sell the key fob :S

anyway possible to program this remote??? cuz i've seen different aftermarket remotes being programmed..