Nissan 350Z License Plate LEDs! See Installed Comparisons! Plug & Play Shipping!
 

Here's a great way to upgrade your 350Z's appearance at night for a very low price. Luxury cars such as BMW, Lexus, Mercedes, come with that nice white LED License Plate illumination. Upgrade and have that look today!

We carry the brightest, highest-quality bulbs at the lowest prices. Your order will ship same day, and we're here if you need us for support and service. And we do not raise the prices to astronomical levels- We're breaking that market trend, and offering you great, low prices, every day. These LED bulbs are designed by us here in St. Louis, and every bulb carries with it a three-year limited warranty.

Our license plate LED bulbs are a direct replacement for your factory license plate bulbs. All white bulbs will provide a cool white LED color, replacing the yellowish incandescent bulb. Or pick red, blue, green, or yellow (off-road use only).

Brightness:

Diode Dynamics offers several brightness options so you can choose what fits you best. These options are listed by the design and the lumen output of each bulb:

SMD2: Slightly higher brightness than OEM bulbs. (24 lumens)
HP3: Much brighter than OEM bulbs. These are bright! (56 lumens)
HP5: Nearly triple the brightness of stock OEM bulbs! (92 lumens)

These bulbs are made up of a quality plastic connector to slide right into the plug, as well as high durability terminals. A load resistor is embedded to prevent blowing the LEDs from voltage surge, and a diode is implanted to protect the LEDs from reverse polarity. The LED is wired for 12V operation, the kind found on all vehicles.

Included in your order is TWO BULBS (to fit your Nissan 350Z).

All of our products come with a 30-day satisfaction guarantee and a 3-year limited warranty.


License Plate LEDs for 2003-2009 Nissan 350Z (pair)

License Plate LEDs for 2009-2016 Nissan 370Z (pair)
License Plate LEDs for 2003-2009 Nissan 350Z (pair)

License Plate LEDs for 2009-2016 Nissan 370Z (pair)

If you have any questions, please don't hesitate to post, PM, email contact@diodedynamics.com or call us: (314) 205-3033

Thanks for looking!

*PM us for the free-shipping code* (U.S. forum members only)

Nick C.

I am going to order some of these I really want to do my interiors as well which would you recommend? I don't want too bright to the point that I'm blinded when I open the doors. I don't want a single incandescent in car.

I'd recommend these for your map lights, they are a good brightness without being too bright:
http://www.diodedynamics.com/catalog...roducts_id=261

We'll be rolling out an all-inclusive kit, tested in the 350Z, next Wednesday. Thanks!

i'll be waiting for that then. I want switchback front signals, reverse, license plate, map light and any other ugly incandescent bulbs.

The switchbacks are sold separately- our kit will include the following, if applicable: dome, map, glove, license, trunk, and door. You can find the switchbacks here:
http://www.diodedynamics.com/catalog...roducts_id=618
One of our most popular items!

Oh that sounds awesome. I will be copping that when it hits the market. Any idea on a cost yet? You should do a group buy on the kit and get some of them out in the streets.

It will be available in stage 1, 2, and 3, based on brightness, with 3 different price points to fit your needs!

g@ddammit.
Put it off for months and just last Wed. I ordered a led kit package online from some co. I had to dig around for.
had to do a bit of mix & match searching through their site to get all the replacements and still missed out a couple bulbs.
always try to support the vendors on here.
maybe I can sell my others ones and get this complete kit when becomes available.

question on the switchbacks in regards to this:
"Resistor Option: Some vehicles may have fast-blinking issues when LED bulbs are installed as turn signal replacements. We offer resistors to remedy this issue."

Does the 350z have the fast blinking issue and require the resistors? Thanks in advance.

I know what you mean- I made these kits because when I tried to do it in my car, it was such a pain to figure out which bulbs I needed. We still give you the option of brightness (stage 1, 2, or 3) but all of the bulbs are tested in the Z for guaranteed fitment. Thanks for your support!

please see edit to my post above with added question. think you responded before my adding it. thanks.

Sorry! Replying too quickly ;)

With LED turn signals, the 350Z will hyperblink, so the resistors are needed if you prefer normal blinking speed. This only applies to turn signal LEDs- everything else can be replaced with no issues.

perfect. exactly what i wanted to know. thanks

So you have a package deal for the 350z? link?

^+1

Finally confirmed a Z for testing on Monday- the LED Kit will be available Tuesday night on our website, and you'll see a new thread for it as well. Thanks guys, looking forward to it!

I'm a little confused on the turn signal comment....? I understand why you need the resistor and all, but which turn signal bulb can you replace with a 194 (T10) bulb? Or are we just talking in general?

Also what would you suggest for the JDM side markers (which take a 194 bulb), and the city light bulbs in the 06+ headlights (which are also 194 bulb)?

in for kit! get a group by whatever let me see numbers and features!

This thread is specifically for license plate bulbs, which are T10 (194) size.

For those bulbs, I'd recommend our 194-5050 SMD bulb. It's one of our most popular options. Very bright!
http://www.diodedynamics.com/catalog...roducts_id=207

Hi I was about to order a pair of these but I cannot decide which level I would like, do you have any pictures in use on vehicles so I can decide? Thanks

Not yet! We will have pictures, though, by the end of this week.