Just installed my Stance coilovers have some q's
 

ok I did my install with my friends and it took us about 3hours.
the driverside front assembly got stuck while we were trying to take it off from the car and it took good 30min to figure it out.
after that it was easy. the back was a joke compare to the front.

I couldn't measure my heigh cause we did not have a rular or anything to mesure. but the back is pretty low compare to stock. (about a 1/2 finger) I need camber kit ASAP..

It rides soo much better.

However, I'm getting clicking noise when I go over the speed mumps from the driver side front and back.
I heard some people get noise from the back but not from the front.

Is there anything that could possibly cause noise from the front?

I did place the front ABS wires to some place they can hold on to also.
tomorrow I'm fging to check it when I have time; but it will be like less than 2hrs.. so..
Any suggestions?

is the noise consistent or intermittent?

the most of clicking and something like shattering metal sound front driver's front. only when I go over speed bumps like when it compresses and gets relesed I hear clicking sound..
any thoughs?

Tighten the top mount bolt on those things (the one where the damper adjustment knob is located). Mine came loose from the factory and i didnt tighten them until i installed them. This worked for me, even though theres little creaks from the back still.

thank you I'll try that tomorrow.
When I'm on the freeway, I don't hear the front just right back side.. currenty (F 7 R 6) out of 15 I don't know we will see.. other than that, it is very good set of coilovers I can say.

you have the worst typing ive ever seen in my life. just thought you should know