Rear camber arm mount gap on new subframe?
 

Recently installed new subframe, in process of reinstalling everything else. Went to install SPL camber arm and there is a fairly large gap between subframe and joint (see pics). My old subframe had SPL arms as well, and it fits in my old subframe fine. I ordered my new subframe using my VIN from dealership, so reasonably certain subframe is correct part. I'm guessing/hoping that new subframes come with that area "oversized" and that I'm supposed to just torque mounting bolt enough to bend subframe flush with joint? It just seems like an awfully large gap to do that with!

Not right, contact SPL

maybe add some washers in there? sounds ghetto and not sure how safe it is but i dont' see no harm by adding washers until u can get a hold of SPL.