Powerlab 3/8's, Strut, A/M Hood Clearance.
 

I have the Powerlab 3/8's plenum spacer, the factory strut bar, and Seibon TS hood and it rubs on the strut bar like a mofo with the spacers on. Does anyone else have this problem? I adjusted the washers as best I could to get it low enough but maybe I did it wrong, its rubbing the factory paint off my strut bar.

If you cannot get the brace to fit properly get one that goes in front of the upper plenum.

Does anyone sell those anymore, I knew crawford used to, but other then that one I can't think of who else sells em.

I remember some members going out to Home Depot and picking up different sized washers to get everything clear... That may be another alternative.
IIRC -Crawford, Greddy and APS were the ones selling strut bars that went in front of the plenum.. IMO, just try and find different sized washers...

GL