ATS clutch question
#1
New Member
Thread Starter
ATS clutch question
Anyone here running an ATS twin carbon plate clutch?
I just installed my twin carbon plate clutch, I did get the proper bearing and sleeve. After putting everything together I noticed some play at the slave cylinder. Usually the fork presses real hard against the slave, right now I have about half an inch if not more play. Any idea if this is normal or no?
Heres a quick video showing the play I'm talking about.
Thanks in advance.
I just installed my twin carbon plate clutch, I did get the proper bearing and sleeve. After putting everything together I noticed some play at the slave cylinder. Usually the fork presses real hard against the slave, right now I have about half an inch if not more play. Any idea if this is normal or no?
Heres a quick video showing the play I'm talking about.
Thanks in advance.
Thread
Thread Starter
Forum
Replies
Last Post