07 350z low/rough idle, then dies
#1
Registered User
Thread Starter
Join Date: Jul 2017
Location: Northern AZ
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
07 350z low/rough idle, then dies
So my hr recently decided to die on me while I was driving, normal driving but when I pushed the gas the engine bogged but it kept on running until I pulled over and tried to start it it would only crank but no start. Fuel pump was priming. After letting it sit for a few hours and taking it home I tried starting it and now it starts but idles very low <500 then dies after about 10 seconds. If I give it gas at all it dies immediately. I'm thinking it could be the cam position sensors, but before I spend the money on those any other ideas? Already tried ecu relearn and checking for vacuum leaks.
#3
Registered User
Thread Starter
Join Date: Jul 2017
Location: Northern AZ
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
#5
Registered User
Thread Starter
Join Date: Jul 2017
Location: Northern AZ
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Yeah no codes but I remember a day or two ago it threw out a p2a00 code so I cleared it and it didn't come back.
Last edited by theredrunner; 02-18-2018 at 05:14 PM.
#7
Registered User
Thread Starter
Join Date: Jul 2017
Location: Northern AZ
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Trending Topics
#9
Registered User
Thread Starter
Join Date: Jul 2017
Location: Northern AZ
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
I'm more than willing to get my hands dirty. I just don't know where to go with the info I have. I see no vacuum leaks anywhere nothing cracked, the gas I'm using is good and the fuel pump is working. Where do I go from here?? I guess I could check if all my spark plugs are sparking but idk of anything else to do.
#11
Registered User
Thread Starter
Join Date: Jul 2017
Location: Northern AZ
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
#12
Registered User
Thread Starter
Join Date: Jul 2017
Location: Northern AZ
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
Update: so gave it another shot today and the car starts and starts to idle normally for one second before dying. Also allowed for me to blip the throttle but then dies right after. Cam position sensors??
The following users liked this post:
Atreyu'z 350 (02-22-2018)
#16
Registered User
Thread Starter
Join Date: Jul 2017
Location: Northern AZ
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
I tried patching it with electrical tape and putting the clamp over that but the car still doesn't run same symptoms still. I'll try buying a new tube and see what happens from there but it looks like it should've sealed with the electrical tape and the clamp over that.
#18
Registered User
Thread Starter
Join Date: Jul 2017
Location: Northern AZ
Posts: 25
Likes: 0
Received 0 Likes
on
0 Posts
I haven't tried listening to it since I've always sat in the while it ran. I'll look at it further today