Aluminum Valve Covers
#1
New Member
Thread Starter
Aluminum Valve Covers
Finally have the aluminum valve covers on. These have serviceable spark plug seals, and you can powdercoat them. One issue I had was some fitment with the driver's side pcv and the oil fill stem, both need to be trimmed. The farthest front passenger side coil pack didnt bolt up, no issues yet though, you can definitely make a bracket though.
#4
New Member
Thread Starter
They are from an 2000-2001 (possibly 2002) Nissan Pathfinder as well as a 2001 Infiiniti QX4
Make sure they have the VQ35de, the older models of the Pathfinder and QX4 have a different engine
Make sure they have the VQ35de, the older models of the Pathfinder and QX4 have a different engine
#7
New Member
Thread Starter
What year pathfinder do you have? The 1999- pathfinders have a different engine, and the ones after 2001 (or 2002) have the VQ35de but have composite valve covers like the z
Trending Topics
#9
New Member
Thread Starter
I like the oil fill stem modification and -an line fittings welded on. Did you mill the raised surface of one of the holes where the coil pack mounts to as well as deleting the crossover nipples? I removed a couple of the extra threaded holes that weren't needed on the valve cover.
Also did you do something so that the OEM 350z coil packs fit? Looks like you may have made the diameter larger so that the coil packs sealed against the valve cover.
Also did you do something so that the OEM 350z coil packs fit? Looks like you may have made the diameter larger so that the coil packs sealed against the valve cover.
#11
New Member
iTrader: (78)
@Kwame care to share some more info on your VC mods? Which filler cap did you end up using? It looks like a Trick Flow push-in style cap that I've seen on Summit before.
The oil filler neck and cap were relocated because of the Jenvey ITB kit I purchased and have yet to install. This is the oil filler neck and cap. https://www.summitracing.com/parts/s...caAurUEALw_wcB
From what I remember the internal baffles were removed to make clearance for the camshaft lobes (I’m running Tomei 280s intake and exhaust). A custom “baffle” was made right on the internal side of the AN fittings. I believe we did shave down the casting for the first coil pack on the passenger side.
That’s all I can remember from over ten years ago.
Thread
Thread Starter
Forum
Replies
Last Post