Blurvision

iTrader: (4)

With a welder and a dream! Keep it coming.

chase z

pretty much . Now I have to decide to paint all the engine parts or just say fu*k it and start finishing this up

chase z

Took a few hours off from working on the car on my off time to make a shelf to free up so room





I all so put the wideband in the oem volt gauge pod idk if i like it but iam not a aftermarket pod kind of guy
I still have to get a new oil pressure gauge to replace the oem one.

chase z

Making the catch can in the space I had to cut out the damaged cores.


Mocked up the catch can. I still have to weld on the fittings and the drain bung

chase z

Cjm parts to convert it to return style fs

Installing nut surts

Mounted now to paint it

chase z

Got a few things media blasted and painted




And moved the battery into the trunk. With a 200 amp breaker

chase z

Had to move that feed for the heater core. I didn't have that pipe on when I made my down pipe and the end hit the dp so I had to cut it off and then move it to the back

chase z

chase z

JetBoost

How much money do you have into your swap?

chase z

my number wouldn't reflect vary well. Lots of the stuff I had and or sold other parts to get the new parts. I had the motor. Sold my 6266 that payed for most of the 369sxe.
I sold my fsr cast maifold that payed for the new top mount .
I sold my r154 with stage 5 clutch that payed for all but $325 of the cd009 adaptor and twin disk clutch.
I had the fuel line and the fuel cell
payed 500 to have my wiring harness adapted to cd009 and added lq9 coil on plug wiring and a few other things.
but when I have time I will go throw everything and give u a real number.

Mike Pickard

How did you go about your driveshaft for this build? Custom or if not then where did you buy it?

KingBaby

iTrader: (3)

Awesome stuff

chase z

it's has to be custom. i made the motor mounts and trans mounts so no one would have a off the shelf driveshaft for me.

chase z

chase z

Not bad Clearance for a 4in turbo back to the tomei ti exhaust. Still have to add a hanger which will bring it up a little as well.

vinniePOOH

iTrader: (34)

This is a SICK build! I wish you were my neighbor! I want to 350JZ mine!

chase z

thanks man. U never know i could live just down the road.

chase z

Exhaust is all welded up and hanger installed u can't even tell there is a 4inch exhaust under there.

chase z

Getting all the wiring wraped up. And I orederd my drive shaft it should be here Monday.