front reflectors installation
#21
Registered User
iTrader: (4)
Join Date: Mar 2006
Location: Lafayette LA
Posts: 3,804
Likes: 0
Received 0 Likes
on
0 Posts
I hadf a air compressor so i jacked the car up. Took off wheel. Undid the 2 screw hold wheel well liner at the bottom corner. Then undid 3 screws holding the underliner and wheellines togther. Pull edge back and reach up there with a screw driver. About same amount of work but another method.
#22
Banned
iTrader: (4)
Join Date: Dec 2006
Location: x
Posts: 2,171
Likes: 0
Received 0 Likes
on
0 Posts
I'm lucky I am a girl and have skinny arms, i just drove onto two rhino ramps then undid the front of the under panel and stuck my arm in between that and the wheel well. Was done in about 10- 20 minutes.
#23
New Member
iTrader: (3)
Originally Posted by t1m1t
You can install without taking off the front bumper, but its A LOT easier to just take it off
1. Lift the Z
2. Take off front bumper (bolts, screws, clips)
3. Unscrew original reflectors
4. Screw on new reflectors
5. Put front bumper back on (bolts, screws, clips)
6. SLOWLY drop the Z
Took me about 10-15 minutes total.
Good luck
1. Lift the Z
2. Take off front bumper (bolts, screws, clips)
3. Unscrew original reflectors
4. Screw on new reflectors
5. Put front bumper back on (bolts, screws, clips)
6. SLOWLY drop the Z
Took me about 10-15 minutes total.
Good luck
Thread
Thread Starter
Forum
Replies
Last Post