jmaestre23

iTrader: (2)

i searched and couldnt find.....i know that it is a little more difficult due to the two bassani mufflers but a pic would be nice thanks

cdoxp800

iTrader: (12)

Try looking here

https://my350z.com/forum/exterior-in...c-request.html

jmaestre23

iTrader: (2)

i just did...reason why i didnt request there is because i figured i would get quicker replies if i posted in the media sections

cbeneke

No pics with the Bassani exhaust in that thread.

cheshirecat79

iTrader: (9)

is it even possible? the upper canister basically sits up inside the bumper with this exhaust. you could cut the rear bumper but i dont see how you could "tuck" it without melting the plastic.

jmaestre23

iTrader: (2)

yeaaa prolly wouldnt work thanks for the info

Nexx

iTrader: (41)

how about you use some painters tape to try it out and post pics for us?

cbeneke

I'd def be curious to see it. I'm looking to get the bassani exhaust, but I've only seen the bumper tuck on exhausts with dual canisters. I think it looks amazing on those cars because you can see the pumpkin. With the Nismo, Bassani, or other similarly styled exhausts, I don't think it would look as good. I'm still curious to see pics though, so post 'em up!

aloh

iTrader: (26)

^ i think you see this mod on single exhausts more than duals.

jmaestre23

iTrader: (2)

yeaaa but it does look good on an hks sooooo clean

cbeneke

It's a necessary mod to the stock bumper with a single exhaust IMO. I think it would look cheesy to have an empty exhaust cutout. Not necessary with an HKS or similarly styled exhaust, but does look very sick.

kelsey_kaye

iTrader: (4)

^+1, but it's pure sex with some exhausts.

Blackheart

iTrader: (21)

or some just find pic of what the bassani exhaust looks like from the rear (before rear bumper is put on) to give us an idea.

LennyFairladyz

iTrader: (1)

Hey guys i was wondering something how do u do the Bumper tuck 2 a 350z

lgear080

iTrader: (21)

If you get a process down... I want it too.
Gotta show off the stainless.

Spork

iTrader: (6)

You know where the screws/bolts hold the supports at the bottom of the rear bumper?

All you do is unbolt these, fold the bottom part of the bumper back, and bolt it into place. You'll have to drill holes in the bottom portion of the bumper.

SS728

iTrader: (15)

I can take a pic of my bumper tuck tomorrow.
The pic basically can tell the install, very self-explanatory.

kramerbuccs24

Got it

red_magic2000

iTrader: (4)

Here you go buddy, look at page 4. Steps with pics. https://my350z.com/forum/exterior-in...request-4.html

lgear080

iTrader: (21)

Lenny. If you do this, wait a bit. I want to do it to mang. I am little busy,
but Sunday?