How'd you mount factory belt receiver to race seats?
 

Have the new seats in and will mainly be using my factory belts, and harnesses only when needed.

Wondering if most people hooked up their electronics to the belt, or clipped wires and mounted it to seat bolts?

Any codes or lights thrown before I decide to pull out the wire clippers i stead of feeding wires through!:dunno:

Thx:thumbup:

I hooked up my stock belts and use them for regular driving too. I kept all the wiring so I can make it like stock if I wanted to sell later on.

Most seat sliders have a bolt on set up for the OEM seattbelt. Just remove the OEM seatbelt that was attached to your factory seat , undo the wires , then install on the new slider and plug in when finished.

Of you could just the two wires on the factory harness to make the car think the seatbelt is always conected. Then when you use a race harness, the seatbelt warning light willnot be on as a distraction.

Excellente' thx gents both good ideas....btw Z sounds great w no passenger seat, lol may just keep her a single shooter!