Rocket Bunny Diffuser Fitting
Anyone fitted a Rocket Bunny diffuser? Trying to work out how to go about mounting, especially the centre section.
Spats (side bits) are presumably a simple case of bolt / rivet to the bumper, but the centre section is pretty heavy and I'm not sure how best to attach it or what to. Cheers |
Rocket bunny diffuser
Did you find anything on making brackets bro havrbt found any?
|
Found a few solutions. Most seem to just bolt to the bumper then hang the front edge with a bit of metal or builder's strap, but this seemed a bit weak.
Couple guys I talked to made full frames to mount to, which is definitely the best way, but lots more work and weight. I bolted to the bumper, then ran 2 rods down to the front edge, with tie rods to the subframe, secured in place with nuts, which seems like a good, strong compromise. Only issue is that if you bottom out, it may take the boot floor with it, as it's only thin. :thumbup: https://cimg1.ibsrv.net/gimg/my350z....9df44c693b.jpg https://cimg5.ibsrv.net/gimg/my350z....f8f292e89e.jpg https://cimg4.ibsrv.net/gimg/my350z....6622463228.jpg https://cimg6.ibsrv.net/gimg/my350z....2fafe22982.jpg |
All times are GMT -8. The time now is 08:26 PM. |
© 2024 MH Sub I, LLC dba Internet Brands