Just installed Strup TP's
 

Just had one question. After installing my TP's I reset the ECU start the car and let it sit for 10 minutes so it gets used to the TPs. So I drive it around the block, at my first run at WOT its fine, my second time around the block, I go WOT then it stalls. Is there a reason why it stalled if so then what is it? Thanks.

Had it happen to my Z and several other cars, immediately after resetting the ECU when going WOT. I assumed it had something to do with the ECU learning process, because it didn't do it any time after that. Sorry I can't tell you why, but you're not alone, and these cars were in perfect working condition, some modded and some not.

i think im going to reset the ecu again and let it sit for a lil bit. then take it out driving. no WOT just daily driving.

installed mine recently
no problems at all
i didnt reset the ecu

Did you install non-foulers?

sorry for the stupid question but whats a non foulers?

also iam about to buy a set of test pipe and just wondering if this will set off your check engine light?and if so is there a way around this?
thanks in advance.

^^+1

bump

If you have a produstion date of 06/04 or earlier the car will most likly not through a cel with test pipes, later production cars will through a light unless you run high flow cats or extend the o/2 sensors out of the main exhaust stream ie non fowlers