Kinetix Racing Plenum Dyno's!!!!!!!!!!!!!
 

So here are a couple of the dyno's that came from The Dyno Shop that I went to this morning.

To keep it short, I got NINE runs today!

three - back to back to back in fifth gear.

three more - back to back to back in fourth gear (dyno guys mistake ;) so he did three more!)

then the last three - back to back to back

all the dynos were done at 10:15 - 10:30 am today. It was probably 60ish degrees.

because I spiffed the guy in the back ($20.00) I only got 5 dynos on the file (but I only paid for four which was $135.00! but he actually did a total of nine. He left out the fourth gear runs (which he said were lower by about 10 pts across the board)

If I have to maybe I can get the others emailed to me but i can make no promises about that.

anyway - here are the numbers...

wait - I need to give a small review of the whole set up...

did a baseline with the folllowing mods -
borla dual, UR pulleys, hybrid injen/pop charger full CAI (which I think helps!) and thats it.
the numbers on that were posted earlier but here they are again.

baselines were 243 and 238 torque run one and
248 and 243 for run two.

so best baseline - 248 rwhp and 243 torque

Ok so a base of 243, How much did you gain?

are you posting the rest?

omg lets see them

the baseline was done on a friday.

THEN I went home and installed a set of Kinetix Hi-Flow Cats. Drove them maybe 50 miles or so (possibly 100) and the next morning went back out for more dynos.

these dyno's show the same mods PLUS the hi-flow cats.

this one is all four runs with the hi-flow cats.

??????What about the plenum??????

now this one shows the best baseline and the best with hi-flow cats (made by, you guess it, Kinetix!)

please keep in mind that these cats only had less than one days use on them and I have been told (and I believe) that after a few days they opened up and are producing more gains than these dynos show.

anyway here is the best baseline and best with hi-flow cats.

So 6 ish hp for the cats?

Almost there
 

I can almost hear "Frank-n-furter" say "Antici.....




















... pation". ;)

the suspense is killing me!

So 5hp gain for the Hi-flo cats.

About 4.5 for the cats then......

Come on!

so, now that we have a semi-base line (including the hi-flow cats)
here are the

NEW NUMBERS WITH THE KINETIX RACING PLENUM.

The numbers are higher than I expected. I think the cat's beaking in some and giving more power (ten extra driving days) has yielded higher numbers, how much is anyones guess!

So after no further delay........

baseline 253

new numbers with all five available runs included.

259 (2 times)
263 (2 times, one is missing)
266.88 and 258.00 torque

the 266 also showed up twice!

I've dated Catholic girls that didn't tease this much!

wow its at least 7-10 hp across the entire range! :D

DAMN, that almost a 20HP gain!!!!!:eek: :eek:

so if you take the best of plenum dyno (266whp), against best of cat dyno(253whp), then you get 13whp gain?!! alright!!

So the Kintetix Plenum provides about 9 HP on a Z with bolt ons already in place. Would a MORE stock Z see more gains than that?

Very impressive for a car with lots of other power mods... very impressive indeed. I bet the results on a stock car would be much better (even the crawford camp has to agree there :D)...

so where do I send the money? ;)

*edit* Do you have any bigger dyno graphs? If you do, please PM them to me or email wren57@aol.com . Thanks.