Steering column comes loose
#1
New Member
Thread Starter
Steering column comes loose
Hey, after I painted and reinstalled my steering column the height adjustment became loose. I took it apart so I could've done something wrong, but I don't think so.
I already grinded down the paint where part 3 and 8 (in the picture) are touching the steering column. I tightened the nut (part 10) with 14, 18 (according to the manual) and even 30 Nm (with the the lock, part 9, in the locked and open position), but after I open and lock part 9 it becomes loose and doesn't lock the steering column anymore ( so I can slide it up and down in the locked position ). If I tighten the nut with more Nm, I can open and lock it several times before it comes loose.
Also I couldn't find part 3, but I think I never had that and installed a washer instead, also didn't help.
I already grinded down the paint where part 3 and 8 (in the picture) are touching the steering column. I tightened the nut (part 10) with 14, 18 (according to the manual) and even 30 Nm (with the the lock, part 9, in the locked and open position), but after I open and lock part 9 it becomes loose and doesn't lock the steering column anymore ( so I can slide it up and down in the locked position ). If I tighten the nut with more Nm, I can open and lock it several times before it comes loose.
Also I couldn't find part 3, but I think I never had that and installed a washer instead, also didn't help.
#4
New Member
Thread Starter
In the manual it only says to tighten the nut with 14 to 18 Nm.
The nut is on the screw and touches nothing else so I think it won't make any difference, but I'll try it out
The nut is on the screw and touches nothing else so I think it won't make any difference, but I'll try it out
Thread
Thread Starter
Forum
Replies
Last Post
nismo_nate
Feedback & Suggestions for Our Forum
2
03-02-2009 09:59 AM