When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Honestly have not pushed it that outside the dyno tune...
a couple of weeks ago I out Q16 and proefi automatically changed maps and was going to 20 psi and I was spinning the r888 tires at 80 mph ..on 760 is fine all day long.... Car revs to 8.6k I think its the setting( full valve work)... I shift it at 8-8.2k
And spool is a bit slower than a tt, but when not spooling ot makes it an easy daily driver honestly...
Last edited by IIQuickSilverII; 12-20-2014 at 08:43 AM.
How did you get rid of the square nuts for the upper control arm bolt?
I was thinking of just plating over them, but with my Vortech installed there isn't room. The cog pulley on the back of the Vortech would interfere with the plate.
By request of member i am posting up a few pics with the way i modded the rear pathfinder kit and modded my stock mani. More manifold mods and spacer will come eventually.